Hydraulic Clutch Slave Cylinder Kit RWD Borg Warner T5 Gearbox - Flat Bearing

£195.00 £234.00
In stock
SKU
AF50
Hydraulic Clutch Slave Cylinder fit to fit our Borg Warner T5 RWD Bellhousing
For use with Ford / Borg Warner T5 Gearbox - Flat Faced Thrust Bearing
CNC machined alloy mounting block with spacers, seals bolts etc

This kit utilises a concentric release bearing and aluminium boss, with modification to the standard gearbox nose. The kit comes completed with all fixings required to convert your existing T5 gearbox. The hydraulic clutch pipe is routed through the original release lever cutout in the bellhousing

The slave cylinder and bearing on this unit work in a different way to a manual installation in that the release bearing is in constant light contact with the clutch diaphragm fingers. This is achieved by an internal spring within the thrust bearing. There is no need to be concerned that the release bearing is in contact with the diaphragm at all times.

Please note that he slave cylinder must be in a partially compressed form when installed. Fitment of the slave cylinder in the extended state will result in the bearing being forced off the end of the inner shaft when the clutch is depressed. When used in a custom installation please check the actuation of the slave cylinder over the entire clutch pedal stroke.

Please note: It is necessary to shorten the original gearbox thrust bearing tube and substitute the original bolts for the longer ones supplied.
See additional image for an drawing of how to achieve this. There is no need to disturb the front gearbox bearing.

When using a shallower clutch cover the release bearing may need spacing forward in order to achieve full clutch depression
To be used with a .625 (5/8") master cylinder

Kit Includes:
Mounting boss
4x spacers
Concentric slave cylinder
2x height adjustment shims
3x 6mm bolts and lock washers
4x 8mm bolts and lock washers

Dimensions:
Mounting plate height: 40mm
Slave cylinder height: 60mm / 40mm fully closed
Assembled height: 100mm open / 80 mm fully closed
Adjustment shims are 3mm thick
Bearing ID: 28.5mm

Thread sizes:
Feed M10 x 1mm thread pitch
Bleed M8 x 1.25mm thread pitch

Top quality part, precision made in the UK
More Information
SKU AF50
Material Steel
brand MST